Test Index

CCNA 200 301 IP Connectivity

© examsnet.com

Question : 78 of 83

Marks: +1, -0

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link.

R1: Ethernet0 is up, line protocol is up

Internet address 192.168.1.2/24, Area 0

Process ID 1, Router ID 192.168.31.33, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State DR, Priority 1

Designated Router (ID) 192.168.31.33, Interface address 192.168.1.2

No backup designated router on this network

Timer intervals configured, Hello 5, Dead 20, Wait 20, Retransmit 5

R2: Ethernet0 is up, line protocol is up

Internet address 192.168 .1 .2 / 24, Area 0

Process ID 2, Router ID 192.168.31.11, Network Type BROADCAST, Cost: 10

Transmit Delay is 1 sec, state DR, Priority 1

Designated Router (ID) 192.168.31.11, Interface address 192.168.1.1

No backup designated router on this network

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem

The OSPF area is not configured properly.
The priority on R1 should be set higher.
The cost on R1 should be set higher.
The hello and dead timers are not configured properly.
A backup designated router needs to be added to the network.
The OSPF process ID numbers must match.

Go to Question:

Prev Question

Next Question