An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any one of three addresses: 192.168.3.1, 192.168.3.2, or 192.168.3.3. Which configuration should be used?

Question

Examsnet · Accepted Answer

Correct Answer is : enable  configure terminal  ip nat pool my pool 192.168.3.1192.168.3.3 prefix-length 30  access-list 1 permit 10.10 .0 .00 .0 .0 .255  ip nat inside source list 1 pool my pool  interface g1/1  ip nat inside  interface g1/2  ip nat outside

CCNA 200-301 Exam IP Services